Tag Archives: Storage

The basics of API 653 tanks reconstruction

API 653 Tanks

API 653 TanksSteel storage tanks are everywhere in the US. They store everything from water to gasoline. However, not all tanks are the same. There are rules and regulations for each type, depending on what they contain. For tanks that store petroleum products, it has to follow the rules under API 653. If you want a tank reconstruction so you can store gasoline, you need to know the regulations.

Definition

API stands for American Petroleum Institute. API 653 is the standard for steel tanks used to store gasoline and petroleum products.  Because these are dangerous and toxic liquids, it is important for the safety of people and the environment to make sure that storage tanks are in good condition. Service providers such as Heartland Tank Services can be of great help in this regard. It is an improvement of the old standard API 650, which replaced API 12C.  However, API 650 is still around. If there are differences between the two standards, API 653 rules apply.

Scope

API 653 inspectors check on all tanks in active service. They make sure that the tanks have no leaks or weak spots that can lead to problems, such as bursting at the seams. They also approve plans to repair, modify, move, and reconstruct storage tanks. They check the bottom, top, shell, and foundation of the tank. Inspectors also test the nozzles and other stuff attached to the tank. If the tank does not fill the minimum requirements, it is not certified.

Use

API 653 applies only to organizations that have their own engineers and technical staff to do any work on the tank. The inspector is part of API to make sure that the work is correct. The rules do not cover everything, however. Anything not detailed in API 653 should observe what is in API 650.

Using a steel tank to store flammable or toxic chemicals is risky. However, if the tank owner follows the API 653 standard, there should be fewer problems. The API website has the latest version of the API 653 guidelines.

Things to Do Before You Put Your Car into Storage

Storage Unit

Storage Unit in PerthThere are some seasons or circumstances when you’d want to put your vehicle into storage. When you have any such plans, it’s necessary to ensure your vehicle is well prepared. The vehicle can develop some problems when it’s not in use. Follow a checklist to ensure your vehicle is ready for storage.

  • Cover and keep it dry

In Perth, cars can get damaged due to temperature changes, weather, moisture, dirt and dust. Find a dry and enclosed area for storage. Car storage spaces are the best option, as they keep the cars dry and clean. It’s also a good idea to keep the vehicle covered by a breathable material, for extra protection against moist air, dust and dirt.

  • Remove the battery

PerthMetroStorage.com.au, a storage company in Perth, says a 10×20 unit is the size of a small car garage. This size gives you enough room for your vehicle, but before storage, you should remove or disconnect all the electronics.

Remove the battery and ensure it stops charging when it’s fully charged. Prevent corrosion by using washers made of felt or similar materials, to keep the posts of various terminals covered. Clean the wiring and protect the various electrical connections from adverse weather conditions.

  • Fill the tank

Moisture can damage the gas tank. Fill the tank completely before you keep your car in the car storage. Add a fuel additive in the full tank of gas. This will prevent the gas from hardening up and blocking up the injectors and carburettor. This will also make sure the gas is ready for use when you remove the car from storage.

Clean the vehicle and get it checked before you put it away. This will protect the interiors, the tyres and the paint when the car’s not in use.